Sunday, April 22, 2018

What is single phasing?

  • A three phase induction motor must be connected to a 3 phase alternating current (ac) power supply of rated voltage. 
  • Once these three-phase motors are started, they will continue to run even if one of the three-phase supply lines gets disconnected. 
  • The loss of current through one of these phase supplies is described as single phasing.

How to Prevent Turbocharger Surging?

  • Cleaning the turbocharger intake filter clean.
  • Regular water-wash the turbine and the compressor side of the turbocharger.
  • In case of exhaust boiler soot blow should be done from time to time.
  • Proper maintenance and checking should be done on turbocharger periodically.
  • Indicator cards to be taken to assess cylinder and power distribution of individual units

What is turbocharger surging?

Turbocharger Surging: কারণ, লক্ষণ ও প্রতিরোধ (বাংলা ব্লগ)

Turbocharger Surging: কারণ, লক্ষণ ও প্রতিরোধ

লিখেছেন: আপনার নাম | প্রকাশিত: ৪ জুন ২০২৫

টার্বোচার্জার সার্জিং (Turbocharger Surging) কী?

টার্বোচার্জার একটি গুরুত্বপূর্ণ যন্ত্রাংশ যা ইঞ্জিনে অতিরিক্ত এয়ার প্রবাহ সরবরাহ করে...

সার্জিং কিভাবে ঘটে?

যখন কমপ্রেসার হঠাৎ করে বায়ুর চাপ ধরে রাখতে ব্যর্থ হয়...

সার্জিং এর লক্ষণসমূহ

  • চিৎকারের মতো শব্দ
  • পারফরম্যান্স কমে যাওয়া
  • বুস্ট গেজ ওঠানামা

সার্জিং প্রতিরোধের উপায়

  1. বুস্ট কন্ট্রোল সঠিকভাবে সেট করা
  2. ইনটেক সিস্টেম ঠিক রাখা
  3. সঠিক টার্বো ব্যবহার করা

উপসংহার

টার্বোচার্জার সার্জিং একটি জটিল সমস্যা হলেও প্রতিরোধ করা যায় সঠিক রক্ষণাবেক্ষণের মাধ্যমে।

এই ব্লগটি আপনার উপকারে এলে শেয়ার করুন এবং কমেন্ট করুন!

When the pressure of the air delivered by the compressor is higher than the pressure inside the compressor, a reverse flow of air is created towards the impeller and inlet of the compressor,
which reduces the speed of the turbine shaft and creates noise and vibration.  This phenomenon is known turbocharger surging.

What are the Causes of Turbocharger Surging?

  • It can be happened due to sudden change in the engine load or speed.
  • Imbalance in cylinder power or faulty injectors
  • Un-cleaned turbine nozzle ring. if the turbine side is dirty i. e nozzle, blades etc enough air can not be produced for combustion.
  • Dirty filter: if the inlet filters are dirty then enough air can not be supplied for combustion, which leads to surging
  • The capacity of turbocharger is larger than required.
  • Increased back-pressure at the turbine side.
  • Improper power distribution between the engine cylinders may cause turbocharger surging as one unit is producing more power and other is producing less. Due to this the air consumption differs, which leads to surging.
  • Highly fouled exhaust i.e. economizer, if fitted may cause back pressure in the turbocharger and thus finally lead to surging.
  • Bad weather – This is one more reason for surging. Due to bad weather sudden load change takes place thus surging.
  • Damaged blades.

Sunday, April 8, 2018

12 volt battery level indicator

It will indicate the charge level of a battery by a LED bar-graph which contains ten LEDs. We use voltage divider theorem to divide the battery voltage because the arduino can take maximum 5V as analog input.

  • Greater than 10.5V (25%)
  • Greater than 11.5V (50%)
  • Greater than 12.5V (75%)
  • Greater than 13.5V (100%)